NZ Delivery: Flat Rate NZ$9.50, AUS Delivery: Weight based from NZ$19. Learn more here

Search

Our customer service hours:

Monday to Friday: 9am-5pm

Saturday & Sunday: closed

09 242 0642

New

F2703001A

Solid Concrete Wet Room Vinyl Wall Tiles - 6 Pack 30.5cm x 30.5cm


Self-adhesive wall tiles that looks like grey concrete. Use these tiles to freshen up the look in your bathroom, laundry or kitchen. These are suitable for wet rooms and can even be applied on the walls in the shower! They are designed to be applied on top of existing flat ceramic wall tiles. 

Product information:

  • sold as a package with 6 sheets
  • covers: 0.55m2
  • each sheet is W: 30.5cm x H: 30.5cm 
  • thickness: 1.4mm
  • waterproof
  • steam resistant
  • no grout needed
  • easy to wipe clean
  • just cut, peel and stick
  • Wet room vinyl wall tiles can be installed on smooth and undamaged surfaces like:

    • painted gib (after a 21-day curing time for fresh paint)
    • smooth ceramic tile
    • shower
    • wall panel (acrylic)
    • metal
    It is not recommended to install wet room vinyl wall tiles on the following surfaces:
    • porous wood
    • relief ceramic tiles
    • textured wallpaper
    • unpainted gib
    • floors
    • bench tops
    • ceilings
    • brick
    • stone

  • Place the wet room vinyl wall tiles in the room at least 48h before application at room temperature ( 20-22°C)

    1. Tools required: Cutter knife, pencil, ruler
    2. Prepare the application surface: The surface must be clean, even, free of dust, oil and grease, and permanently dry. Level out any unevenness with a filler.
    3. Application: Peel off the backing paper from the overhanging backing film and stick the tile to the wall. Glue the next wall tile overlapping the overhang of the previous tile edge to edge.
    4. Cut to size: If necessary, cut the wall tiles to size. To do this, position a rule and run the cutter knife along it two or three times.
    5. Seal: Be sure to seal all outer edges with silicone, especially in wet rooms. This prevents moisture from penetrating. Air the room well afterwards.
    This video show how to apply wet room wall tiles
    We recommend that you read our FAQ page before installing the Wet Room Wall Tiles.

  • Calculate the surface you need to cover. This is easiest done by splitting each surface into rectangular sections. Each pack covers 0.55m2. We recommend adding a minimum of 10% extra for wastage.

  • Clean the tiles with a light, commercially available liquid cleaner or soapy water. Then rinse thoroughly with clear water. Caution: Avoid acetone, mineral spirits and direct heat at all costs.

Customer Reviews

No reviews yet
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)

Search