NZ Delivery: Flat Rate NZ$9.50, AUS Delivery: Weight based from NZ$19. Learn more here

Search

Our customer service hours:

Monday to Friday: 9am-5pm

Saturday & Sunday: closed

09 242 0642

SAMPLE-WR602

Sample Premium Marble Wet Room Vinyl Wall Tiles


Design:

Premium marble in grey and white

Sample Size:

The samples are 1/4 of a tile and approximately: 15.25 x 15.25cm

Product Information:

  • waterproof (and suitable for the shower)
  • self-adhesive
  • steam resistant
  • no grout needed
  • easy to wipe clean
  • just cut, peel and stick

To find out if these tiles are suitable for your project we recommend that you order a sample first and check the design, colour and quality. You will see how easy it is to apply, clean and remove.

  • Wet room vinyl wall tiles can be installed on smooth and undamaged surfaces like:

    • painted gib (after a 21-day curing time for fresh paint)
    • smooth ceramic tile
    • shower
    • wall panel (acrylic)
    • metal
    It is not recommended to install wet room vinyl wall tiles on the following surfaces:
    • porous wood
    • relief ceramic tiles
    • textured wallpaper
    • unpainted gib
    • floors
    • bench tops
    • ceilings
    • brick
    • stone

  • Place the wet room vinyl wall tiles in the room at least 48h before application at room temperature ( 20-22°C)

    1. Tools required: Cutter knife, pencil, ruler
    2. Prepare the application surface: The surface must be clean, even, free of dust, oil and grease, and permanently dry. Level out any unevenness with a filler.
    3. Application: Peel off the backing paper from the overhanging backing film and stick the tile to the wall. Glue the next wall tile overlapping the overhang of the previous tile edge to edge.
    4. Cut to size: If necessary, cut the wall tiles to size. To do this, position a rule and run the cutter knife along it two or three times.
    5. Seal: Be sure to seal all outer edges with silicone, especially in wet rooms. This prevents moisture from penetrating. Air the room well afterwards.
    This video show how to apply wet room wall tiles
    We recommend that you read our FAQ page before installing the Wet Room Wall Tiles.

  • Calculate the surface you need to cover. This is easiest done by splitting each surface into rectangular sections. Each pack covers 0.55m2. We recommend adding a minimum of 10% extra for wastage.

  • Clean the tiles with a light, commercially available liquid cleaner or soapy water. Then rinse thoroughly with clear water. Caution: Avoid acetone, mineral spirits and direct heat at all costs.

Customer Reviews

No reviews yet
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)

Search